Filter
Top Products
23. 22.
BASIC OPERATION
On / Off
To avoid unnecessary power consumption, please set FUNCTION selector to OFF position when
the unit is not in use. In ON mode the POWER indicator turns red.
1. Select the desired mode with the FUNCTION selector: RADIO, TAPE / OFF or CD / MP3 / USB
/ SD.
2. Set the desired volume with VOLUME + / -.
3. Set the FUNCTION selector to OFF position to turn off the unit.
RADIO RECEPTION
Recommendations for better reception:
UKW (FM): Fully extend the telescopic antenna and turn it for better
reception. If the reception signal is too strong (e.g. near a
station), shorten the telescopic antenna.
Medium Wave (AM): The device has a built-in AM-antenna; change the position of
the device if reception is poor.
Radio Operation
1. Set the FUNCTION selector to RADIO position.
2. Select the desired frequency band with the BAND selector: FM, FM ST. or AM.
3. Tune into your favorite radio station with TUNING control.
4. If selecting FM stereo and tuning into a stereo station, FM ST. on front of the unit turns on.
5. Set the desired volume with VOLUME + / -.
6. Set the FUNCTION selector to OFF position to turn off the unit.
CD Playback
The CD-player can read Audio CDs, MP3 CDs, CD-R and CD-RW discs. Do not attempt to play
Data CDs or VCD / DVD discs.
1. Set the FUNCTION selector to CD / MP3 / USB / SD position. The display shows “- - -” for a
moment.
2. Open the CD compartment manually with the recessed grip OPEN; OP is displayed.
3. Insert a CD, CD-R or CD-RW with the label up and close the CD compartment again manually.
At first the total number of tracks is displayed for a moment, afterwards the display changes to
► 01 and playback starts automatically. The corresponding track number is displayed.
4. In case playback does not start (depending on the disc), please press PLAY / PAUSE to
start playback of the first track manually.
5. Press PLAY / PAUSE to pause playback; press again to continue playback. In pause mode
► flashes.
6. Press STOP to stop playback; the display again shows the total number of tracks.
Notes: CD playback is also stopped when:
a. opening the CD compartment;
b. sliding the FUNCTION selector to RADIO or TAPE / OFF positions;
c. all tracks on the CD have been played.
Skip Mode
In playback mode press SKIP- or SKIP+ to skip to the previous or next track.
1. Select the track in playback, stop or pause modes with SKIP- or SKIP+ and start playback by
pressing PLAY / PAUSE.
2. Press SKIP+ repeatedly to skip to the next track(s), until the desired track number is displayed.
3. Press SKIP- once to skip to the beginning of the current track.
4. Press SKIP- repeatedly to skip to the previous track(s).
Fast Forward And Rewind
Press and hold SKIP+ or SKIP- to access fast forward or rewind functions through the track to
search for a certain position.
Program Playback
Up to 20 tracks can be programmed in your desired sequence; any track can be programmed more
than once.
1. Before programming, please press STOP and MODE. The display shows P01 and PROG.
2. Select the first desired track with SKIP+ or SKIP-.
3. Save the track with MODE. P02 and PROG flash in the display. Now select the next track.
4. Repeat steps 2 and 3 to program further tracks, the maximum number of tracks is 20.
5. Press PLAY / PAUSE to start playback of the tracks in your desired sequence.
Delete Program
Follow these steps to delete the program:
1. Open the CD compartment.
2. Set the FUNCTION selector to RADIO or TAPE / OFF positions.
3. Press STOP.
Notes for CD-R / CD-RW users:
Depending on CD burner, make of CD and burner speed, reading problems may occur.
Playback Modes
Several playback modes are available on the unit; press MODE to access and select.
1. Press MODE once to repeat the current track. The display shows REP besides track number
and ►.
2. Press MODE twice to repeat the disc in its original sequence. The display shows REP ALL
besides track number and ►.
3. Press MODE three times to play all tracks on the disc once in random sequence. The display
shows RAND besides track number and ►.
4. Press MODE again to return to normal playback mode. The display shows again track number
and ►.