Elta 2402N CD Player User Manual


 
18.
Disc playback
1. Insert a CD (see section “Inserting a disc”).
2. Start the playback with (1) at the device or PLAY / PAUSE (1) on the remote control. The display
shows the current track number (e.g. “01.”). The dot “.” on the right indicates the playback mode.
3. Adjust the volume with the VOLUME (12).
4. To pause the playback press again at the device or PLAY / PAUSE (1) on the remote control. The
current track number flashes on the display. Continue the playback by pressing (1) again at the device
or PLAY / PAUSE (1) on the remote control.
5. To stop the playback press (8) at the device or STOP (4) on the remote control, the display shows the
total number of tracks.
Notes:
The CD playback will also be canceled, if:
a. the door of the CD drive is opened with /OPEN.
b. the function selector FUNCTION (11) is set to the RADIO position.
c. all tracks of the CD are played.
6. Remove the CD (see section “Removing a disc”)
7. Turn off the device by setting FUNCTION (11) to the OFF position.
Note: Please observe that the CD continues to rotate also in the pause mode, even as no sound can be
heard. Don’t forget to turn off the pause mode, to prevent needless operation of the motor.
Selecting a different track (SKIP in the stop mode and during playback)
During playback you can skip to the previous or next track with (6) or (7) at the device or with
SKIP - (2) or SKIP + (5) on the remote control.
1. During the playback, stop or pause mode select the track and start the playback with (1) at the device
or PLAY / PAUSE (1) on the remote control.
2. Briefly press (7) at the device or SKIP + (5) on the remote control to skip to the next track or press
repeatedly on this key, until the desired track number is shown on the display.
3. Press (6) on the device or SKIP - (2) on the remote control to return to the beginning of the current
track.
4. Press again (within 1 second after the first key stroke) (6) or SKIP - (2) on the remote control to skip
back one track at a time.
Searching a certain position (during playback)
Press and hold (6) or (7) at the device or SKIP - (2) or SKIP + (5) on the remote control to search
for the desired position within the track. The normal playback continues when the button is released.
Note: In search mode the volume is reduced.
Programming of tracks
Up to 20 tracks can be programmed in an arbitrary order. A track can be programmed more than one time.
The CD player must be in the stop mode ( (8) at the device or STOP (4) on the remote control).
1. Invoke the program mode with PROGAM (3) or on the remote control. The display shows briefly “01“
(memory location number) and afterwards “00“ flashes.
2. Select with the desired track with (6) or (7) at the device or with SKIP - (2) or SKIP + (5) on the
remote control.
3. Store the selected title by pressing PROGAM (3) at the device or on the remote control.
4. Repeat the steps 2 and 3 to program further tracks. The memory location number will be increased
automatically.
5. Start the playback of the programmed tracks with (1) at the device or PLAY / PAUSE (1) on the
remote control.
6. By pressing (8) twice at the device or STOP (4) on the remote control the
programmed playback will be canceled.