Electro-Voice XI-2181AF Home Theater System User Manual


  Open as PDF
of 2
 
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 736-4212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 8/2004
Part Number 38110-279 Rev. A
Architectural & Engineering Specs:
Dimension Drawings (Flying Version Shown):
Impedance:Frequency Response (Full & Half Space):
This Xi Loudspeaker should be suspended overhead only in accordance with the procedures and limitations specified in the
X-Array Xi Install Flying Manual
and possible manual update notices. This system should be suspended with certified rigging
hardware by an authorized rigging professional and in compliance with local, state, and federal overhead suspension ordinances.
CAUTION
Performance Match
• P3000 (RL) • CPS 2.8 • Dx38
• P1200 (RL) • CPS 2.11
Wiring/Connection Chart:
:1FL1sniP
delellaraP
:2FL2sniP
delellaraP
delellaraP4&3sniP
srotcennoCneewteB
The loudspeaker system shall be a dual driver, manifolded, vented-box low-frequency system. The loudspeaker system shall have
two (2) 18-inch low-frequency woofers. The woofers shall have 8-ohm, 4-inch-diameter voice coils constructed of aluminum wire,
which shall be capable of handling a 1200-watt shaped pinknoise signal with a 6-dB crest factor for 8 hours (as per ANSI/EIA RS-426A
& AES 2-1984). The loudspeaker system shall have a sensitivity of 102 dB (1 watt at 1 meter). The loudspeaker system shall have an
enclosure constructed of 18-mm, 13-ply birch plywood and shall have a vinyl-clad steel grille. The flying version shall employ flying
hardware of a “track” style and two tracks on the enclosure top and two tracks on the enclosure bottom. The loudspeaker dimensions
shall be 914 mm (36.00 in.) high, by 586 mm (23.07 in.) wide and 759 mm (29.88 in.) deep and shall weigh 83.5 kg (184 lbs).
The loudspeaker shall be the Electro-Voice
®
Xi-2181A or Xi-2181AF.
Xi-2181A Part Numbers
• 1059-3421 - Black
• 1059-3427 - White
Xi-2181AF Part Numbers
• 1059-3420 - Black
• 1059-3428 - White
 previous