Filter
Top Products
Architecture & Engineering Specs:
The loudspeaker shall be a two-way system consisting of two 4” (102mm)
low-frequency transducers, 1” (25mm) high-frequency transducer with
a Coherent Coverage Waveguide, and frequency-dividing network
installed in a vented, line array enclosure. The network shall include a
passive limiter for both the low frequency and high frequency transducers.
The loudspeaker system shall meet the following performance criteria:
Power handling, 200 watts of EIA RS-426A continuous pink noise (6 dB
crest factor); Frequency response, 65 Hz – 20 kHz (-10 dB from rated
sensitivity); Pressure sensitivity, 89 dB at one watt, 200 Hz – 10 kHz at
one meter; Impedance, 8 ohms nominal, 6 ohms minimum. The high
frequency transducer shall drive a waveguide to evenly cover 120°
horizontally by 80° vertically. The enclosure shall be molded of acrylic
butyl styrene. The enclosure shall be 12.2” (310mm) high, 6.9” (175mm)
wide, 8.5” (216mm) deep. The finish shall be a paintable black or white.
The grille shall be zinc plated, powder coated for corrosion resistance,
and restrained with a safety leash. The loudspeaker shall be adjustable
over a range of 100° horizontally and 90° vertically. The support bracket
shall be low profile and integral with the enclosure. The system shall be
weather resistant to MIL Spec 810 and IEC 529 IP 34 test conditions. The
surface mount loudspeaker shall be the Electro-Voice® EVID model
4.2.
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 887-9212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 12/2005
Part Number 38109-982 Rev E
Beamwidth:
Frequency Response:
Directivity:
Block Diagram:
INPUT
LPF
HPF
Passive
Limiter
+
Side
Wall Plate
Front
Top
Performance Match:
• EVID 12.1 Sub
Available Accessories:
• HS-3 Horizontal Mount Desk Stand for 3.2/4.2
• VS-4 Vertical Mount Desk Stand for 4.2
• AB-ZE Array Bracket Kit for 2 or 4 ZX1i or EVID Systems, Black
• TC-4B Black Weatherized Terminal Cover for 4.2
• TC-4W White Weatherized Terminal Cover for 4.2
EVID 4.2 Part Numbers:
301046-001 Black
301046-002 White
301046-003 Black, Transformer
301046-004 White, Transformer
Dimension Drawings: