Filter
Top Products
General Description (Cont’):
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 887-9212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 2/2002
Part Number 38110-094 Rev. A
Dimension Drawings:
Frequency Response (On a Tube):
Frequency Response (On an HP64M Horn):
DH2T-8 Part Number: 834-PA-2680
DH2T-16 Part Number: 834-PA-3391
Top View
Side View
Bottom View
Pure aluminum rectangular voice coil wire is used to obtain
the highest sensitivity. Proprietary bonding and winding
technologies assure unsurpassed reliability and performance
of all DH2T diaphragm assemblies.
Electro-Voice’s commitment to precision compression driver
manufacturing and modern design techniques assure the
DH2T user the highest level of audio and engineering
excellence.
Accessories:
• ADH-3 Adapter (For 1.38” Exit) 588-587
(must be purchased separately)
• ADH-5 Adapter (For 2.0” Exit) 588-2855
(must be purchased separately)
Side View
(Shown with
Optional ADH-3
Adapter)
Note: Frequency response and impedance of the DH2T-16 driver attatched to a
25mm (1.0”) diameter plane wave tube, using one watt input (4 Vrms).
Note: Frequency response and impedance of the DH2T-16 driver attached to an
HP64M Horn, measured on axis in the far field using one watt input (4 Vrms). SPL
calculated to 1 meter equivalent by inverse square law.
Dimension Drawings (Cont’):
Side View
(Shown with
Optional ADH-5
Adapter)