Filter
Top Products
SPECIFICATIONS:
Surround sound speaker systems using 5.1 format are designed to connect to compatible audio devices offering
5.1 output. Many pc s and DVD players already offer this type of output. If you only have a 2 channel stereo
output it may be possible to purchase a Dolby digital 5.1 decoder which will convert this into a 5.1 format. This is
not included with these speakers. If you must use a 2 channel input then this should be connected to the front L
and front R input. This will result in a stereo output only.
1.POSITIONING
If you have the 5.1 surround sound input then you can experience the full performance of this system. You will
have the indivedual outputs for the subwoofer, front stereo, rear stereo and front centre speakers. Position the
front stereo speakers in front of the listening position and an equal distance to the left and right sides. Ideally the
speakers should be about ear height(when sitting to listen)if possible and slightly away from a rear wall but they
can be hooded onto a wall if necessary. If they are placed on a slippery surface, a little blue-tack may help hold
them in place. These speakers contribute a lot to the overall audio so careful placement is crucial to your
enjoyment of the music.
The centre speaker should be placed on your TV screen or your computer screen(depending upon
application)as this speaker is used for vocal content. The voices in a movie need to sound as though they are
coming from the Tv set so try positioning this on top of the set.
The rear speakers are used for special effects and are not as crucial in their placement. A good position for these
is high up on the wall behind the listening position, perhaps pointing downward a little.
The subwoofer houses a powerful bass driver and the positioning of this unit can have an effect on the quality of
the bass. If the unit is placed in a corner, the bass will be amplified by the reflection from the walls. This position
will give maximum bass but can sound quite boomy. A position near a rear wall but away from the corner is best
as this will give a little boost to the bass without being too much. Experiment with the position to achieve best
results. Also note that the unit receives the signals from the remote control. The range of transmission from the
remote is not too great so don`t position the bass unit too far from the listening position.
2.CONNECTING
(1).Switch off the power first before connecting any part of the system.
(2).Connect all 5 satellite speakers to their relative speaker output spring clips on the rear panel of the
subwoofer. Please note to match the colour, red to red and black to black. Note that the cable for the rear
speakers is longer than the front.
(3).Connect the inputs to your PC or DVD player as shown in figure.
(4).Plug the AC power plug into the wall outlet, as shown in figure.
OPERATING INSTRUCTIONS:
Total Power Output :
Input Impedance:
Input Sensitive:
Bass Unit:
M
Tweeter Unit:
Frequency Response:
Dimension(Subwoofer):
Dimension(Satellite):
Gross Weight:
id-range Unit:
RMS 6WX5+30W
10K Ohm
450 mV
Aluminum coil, 4 Ohm
3 Paper coil, 4 Ohm
1
42 Hz ~ 20 KHz
290(W) x 193(H) x 285(D)mm
96(W) x 167(H) x 108(D)mm
About 11Kg
6 1/2
PV membrane dome