Filter
Top Products
• Low frequency array module
• Two 15 inch woofers
• Engineered to array with MQ1300 MF/HF modules
• For permanent installation only
• Digital signal processor required for specified performance
The MQ1215 uses two direct radiating 15 inch cones mounted
in a vented trapezoidal enclosure. Its frequency response has
been optimized for use as a dedicated low frequency system
when used with a companion MQ mid/high loudspeaker. Each
driver has its own connections on the input panel. This allows
the drivers to be connected in parallel to one amplifier chan-
nel or connected individually to separate amplifier channels.
The enclosure features a comprehensive system of 3/8-16
threaded suspension points.
The MQ Series comprises matched sets of mid/high and low fre-
quency enclosures with complementary dimensions. This facil-
itates creating attractive arrays that provide high definition
sound within tightly controlled coverage areas. The MQ1215 is
designed to work with a complementary MQ1300 Series
mid/high loudspeaker to create a full range audio system. The
enclosure is vertically configured for arraying in horizontal
rows. Horizontal arrays are typically used in venues where the
array must address wide, fan-shaped audiences.
The most common array configuration is two MQ1364e's or
MQ1366e's separated by a single MQ1215. In such an array, the
MQ1364e's or MQ1366e's should be splayed 25° to either side
of the MQ2315, netting a splay angle of 50° between mid/high
modules. When arraying two MQ1394e's separated by a single
MQ1215, all enclosures should be tight-packed to achieve opti-
mal coverage. This configuration will net a splay angle of 80°
between mid/high modules. All splay angles reference the cen-
ter line of the enclosures.
SPECIFICATIONS MQ1215
DESCRIPTION
APPLICATION
FEATURES
PHYSICAL
PERFORMANCE
One Main Street, Whitinsville, MA 01588 508 234 6158 Toll Free 800 992 5013 FAX 508 234 8251 info@eaw.com www.eaw.com
EAW products are continually improved. All specifications are therefore subject to change without notice. MQ1215/0004850/001/2 pp September 2002 Printed in USA
Configuration Dedicated LF module
LF Subsystem 2x 15 in woofers
Enclosure Material
Exterior grade Baltic birch plywood
Finish
Wear resistant textured black paint
Connectors 4-contact barrier strip &
1x Neutrik NL4 Speakon
Suspension Hardware 16x 3/8"-16 threaded mounting/
suspension points (4 each top,
bottom and sides)
Grille Powder coated perforated steel
Dimensions inches millimeters
Height 40.00 1016
Width (front) 24.00 610
Width (rear) 12.75 324
Depth 21.00 533
Trapezoid Angle 15° per side
Weights pounds kilograms
Net Weight 128 58.2
Shipping Weight 140 63.6
Frequency Response
±3 dB 50 Hz to 1.3 kHz
-10 dB 40 Hz
Axial Sensitivity (dB SPL, 1 W @ 1 m)
LF 100
Impedance (Ohms)
LF1/LF2 8/8
LF Paralleled 4
Power Handling, AES Standard (Watts)
LF1/LF2 800/800
LF Paralleled 1600
Calculated Maximum Output (dB SPL)
LF Peak 138
LF Long Term 132
Nominal Coverage Angle/-6 dB points (degrees)
Horizontal 160
Vertical 100
Recommended High-Pass Frequency
24 dB/Octave 40 Hz