Filter
Top Products
PH1000W/2
30A Fuse
Speaker Outputs
Minimum 4 Ohm Mono
The gain knob is not a volume control.
It is designed to match the input level
of the amp to the output level of the
source unit. Over driving -clipping- the
input stage of the amp will cause
damage to the amplifier (Please refer
to table for settings).
POWER
Born In The USA
FUSE
CH2CH1
MONO
SPEAKER
Crossed RCA level
outputs, can be used
to feed other amplifiers
in the system.
3-way switch feeds RCA
outputs a low-pass full-
range or high pass signal.
Set Xover knob to
Minimum (20Hz), &
set Xover switch to
Full Range
The PH1000W/2 is designed to
operate in stereo or mono mode. When
used in stereo applications, a minimum
load of 2 ohms per channel is required.
The PH1000W/2 is designed to
operate in mono mode. When
bridging the two channels, a
minimum load of 4-ohms is
required.
RCA level inputs, with
a range of 0.2V to 5V.
RMS.
+18dB boost @ 45Hz
designed to shape/
boost the response
curve in a low-pass
mode application.
+12dB boost @
12kHz essential
boost for high-pass
amplifier applications
3-way switch
runs the amp
in low-pass,
full-range or
high-pass
mode.
8 9
Specifications Are Subject To Change Without Notice www.earthquakesound.com
REM GNDBAT
To car chassis / ground
To remote turn on / trigger
To battery (+)
FC6.2
Tweeter
FC6.2
Tweeter
FC6.2 Midrange FC6.2 Midrange