Earthquake Sound MC6 Speaker User Manual


  Open as PDF
of 4
 
All specifications are subject to change without notice.
EARTHQUAKE SOUND
6
EARTHQUAKE SOUND • INSTALLATION
CROSSOVER
TWEETER
WOOFER
7
GRILLE 4 S H E E T M E T A L
SCREWS PER SPEAKER
GRILLE TRAY
CUSTOM SPEAKER INSTALLATION
4 S H E E T M E T A L
SCREWS PER SPEAKER
SPEAKER
FACTORY REPLACEMENT INSTALLATION
MOUNTING CLIPSFACTORY CUTOUT
NOTE:
Hand tighten the screws
in a crisscross pattern to
avoid bending the speaker
basket or stripping screws.
INSTALLATION APPLIES
TO BOTH COMPONENT
AND COAXIAL SPEAKERS
NOTE:
INSTALLATION APPLIES
TO BOTH COMPONENT
AND COAXIAL SPEAKERS
NOTE:
SURFACE MOUNT FLUSH MOUNT COMPLETE ASSEMBLY
Push assembled tweeter through cut out hole
Cut diameter: EQM-T=2.15” (54.7mm)
Twist on nut
until the
tweeter is
secured
Fasten the panel
clamp down from
behind the panel.
Panel
Panel Clamp
Cup Mount
First pre-wire
your water craft
if not using stock
p l a c e m e n t .
Mount cup in
desired place.
T h e n p u s h
tweeter inside
cup until you
hear the snap.
This indicates
a secure fit.
COMPONENT SET WIRING DIAGRAM
AMPLIFIER
 previous