Filter
Top Products
AC outlets on the same circuit breaker
Power strip
Tape Deck
DVD
Pre-amplifier
Amplifier
Subwoofer
Earthquake • MiniMe User Manual
8
• Choose reliable, high quality interconnect cables,
Connections
also called patch cords or RCA cables. They should
Please consider the following when setting up
be fully shielded and as short as possible for the job.
your new system:
The longest cable in your system will likely be to the
subwoofer, so choose a good quality brand.
• Before making or changing any connections,
ALWAYS make sure that the subwoofer is unplugged
• Some patch cords can be a very tight fit and there is
from the wall and your other components are turned
usually a preferred method of getting them off. Some
OFF. Also, turn down the volume control of the
have to be re=moved with a twisting action. Be gentle
subwoofer and your pre-amplifier or receiver.
or you may damage the jacks of the subwoofer or
your other components.
Speaker Level Connections
• The subwoofer's Speaker Level Inputs can accept
speaker stripped speaker wires only.
• Make sure that the negative speaker wires never
touch the positive wires as this will short out and
possibly damage your amplifier or receiver.
• This diagram shows all the low power components
sharing a power strip which is connected to the same
outlet used by the amplifier.
• The subwoofer is connected to an outlet on the
same circuit breaker, provided that the total system
current draw does not exceed the breaker current
rating.
• This arrangement will reduce the possibility of an
audible hum in your system caused by a ground loop.
• Whenever possible, keep the power cords away
from the signal cable or speaker wires to prevent any
hum or inference being heard in speakers.