Filter
Top Products
Flush Mount Assembly
Flush Mount Installation
Top Ring
Panel
Mounting screws
Earthquake has provided two (2)
mounting screws to be used in
the Angle and Surface options
Angle Mount Assembly & Installation
Bottom Cup
Flush Mount Complete assembly
Surface Mount Assembly & Installation
Top Ring
Panel
Bottom Cup
Push assembled tweeter through cut out hole
Cut diameter: VTEK-25S= 2” (50.8mm)
Twist on nut
until the
tweeter is
secured
Fasten the panel
clamp down from
behind the panel.
Panel
Panel Clamp
Top Ring
Make sure that
the top ring and
bottom cup snap
when pushed
together
Bottom Cup
FACTORY REPLACEMENT INSTALLATION
NOTE:
Hand tighten the screws
in a crisscross pattern to
avoid bending the speaker
basket or stripping screws.
INSTALLATION APPLIES
TO BOTH COMPONENT
AND COAXIAL SPEAKERS
NOTE:
INSTALLATION APPLIES
TO BOTH COMPONENT
AND COAXIAL SPEAKERS
NOTE:
CUSTOM SPEAKER INSTALLATION
4 SCREWS PER SPEAKER GRILLE TRAYGRILLE
4 SCREWS PER SPEAKER SPEAKER
MOUNTING CLIPSFACTORY CUTOUT
8
All specifications are subject to change without notice.
www.earthquakesound.com
9