Filter
Top Products
4 Dynaudio Focus
Connecting
2. Connect the other cable ends to the loudspeaker outputs of your switched off power
amp (see Fig. 2).
Note
Please make sure that the red marked post of the speaker is connected to the red
marked output of the amp, and the white or black marked post to the white or black
marked output accordingly.
Bi-wiring/bi-amping
Dynaudio loudspeakers feature a carefully fine-tuned cross-over, optimized using
selected parts and an advanced circuitry to achieve a truly balanced and smooth
frequency response. Therefore, dividing the frequency sections through bi-wiring or
bi-amping is neither beneficial nor optional.
Choice of loudspeaker cable
The impact a loudspeaker cable can have on sound quality may be dramatic, though in
general quality cable products will yield a quality result.
Dynaudio loudspeakers are designed to be very neutral and thus are not extremely suited
to any particular type of cable. The choice of cable is as much a factor of matching the
cable to the entire audio system. Please consult your Dynaudio dealer for information
about compatible loudspeaker cables that will suit both your electronics and the Focus
loudspeakers.
Connecting surround speakers
When connecting a two-channel stereo system, only the right and left channels are
connected to the amplifier.
In a surround set-up, center, side or rear loudspeakers as well as a subwoofer are
typivally connected to provide for a multi-channel listening experience. Please refer to the
amplifier’s owner manual for particular connection instructions and see chapter “Multi-
channel loudspeaker setup” on page 10 for further help.
Fig. 2 Amplifier loudspeaker outputs (example).
www.fshifi.cn