Filter
Top Products
Quick Start
Caution: Before switching on the power of the SUB800A always set the LEVEL control
to its counterclockwise stop. A playing sound source could otherwise lead to extreme
output levels.
This Quick Start Manual outlines the set up and operation of a SUB800A used as add-on subwoofer
together with a PowerMate (see configuration examples). The operation procedures are equivalent for
other mixers.
1. Set up your PowerMate system as usual and connect a signal source to the power mixer
(e.g. CD Player or microphone).
2. Place your SUB800A somewhere between your full-range cabinets.
3. Set the SUB800A’s LEVEL control to its counterclockwise stop and connect the unit to a wall outlet
using the supplied PowerCon mains cord.
4. Use a stereo phone plug cable to connect the PowerMate’s MONO OUT to the SUB800A’s
L/MONO INPUT.
5. Close the PowerMate’s MONO OUT fader all the way.
6. Be sure to switch on the PowerMate first and then the SUB800A.
Switching on the SUB800A last is recommended. Otherwise, unwanted power-on noise might occur.
When switching off your equipment, please proceed in the opposite order, i.e. switch off the
SUB800A first.
7. Set the SUB800A’s LEVEL control to its center position (0dB) and start the playback of the desired
signal audio source.
8. After adjusting the desired acoustic output level of the full-range cabinets using the PowerMate’s
master fader, establish volume setting for the subwoofer using the MONO OUT fader.
QUICK START
11