Dual DA604D Stereo Amplifier User Manual


 
High-Level Input
(speaker cables)
Low-Level Input
(RCA)
Speaker Connections
Connect speaker wires
observing polarity.The
minimum impedance load
for the DA604D and DA954D
is 2 ohms stereo and 2
ohms bridged. Use of loads
lower than these is not
recommended and may
cause amplifier damage.The
DA604D and DA954D can be
wired for stereo, bridged or
stereo/bridged simultaneous
operation.
Input Signal Connections
Low Level Input (RCA)
Low level (RCA) input signal is preferred for best performance.Typical trunk-
mount amplifier installations require a 17-20 foot RCA cable. Most trucks
and under-seat applications require a 6-9foot RCA cable. Using twisted pair
construction RCA cables will minimize noise.
High Level Input
(Speaker Wire)
High level inputs should only
be used when RCA outputs are
not available from the head unit.
Connect the head unit speaker
outputs to the high level input
connector as shown below. The
black wire (signal reference
ground) may or may not require a
connection to chassis ground
-depending on your particular
installation.
Subwoofer (mono)
Typical Bridged Wiring
(2 ohms minimum)
2 Speakers (stereo)
Typical Stereo Wiring
(2 ohms minimum)
Note: Do not use both low and high level inputs
at the same time connect only one or the other.
Typical speaker connections shown
7
INSTALLATION
Amplifier Connections