Filter
Top Products
7
SR835 Crossover
Begin sending signal through the system.Gradually increase the High,then Mid,
and finally Low Levels in order checking for correct wiring.Then balance the
tonality of the source signal.You may also need to increase the Gain if a stronger
signal is required.
STEREO USING A MONO SUB-WOOFER
The setup procedure is the same as for the stereo bi amp application, except
that instead of connecting both low frequency outputs, connect only the Low
Frequency Sum output to the low frequency amplifier. Set both Channel 1 and
Channel 2 Low Level controls to the same level to ensure that both controls
contribute the same amount of signal to the Low Frequency Sum output.
MAINTENANCE AND SERVICING
There are NO user serviceable parts inside the units. Opening the chassis will
void the warranty. All service and repair must be performed by the factory or
an authorized service center for the warranty to remain in service.
Should a problem arise with the equalizer,please contact your authorized DOD
Electronics dealer for return/repair procedures.
SPECIFICATIONS
Frequency Response: 10Hz.to 22kHz +0/-0.5 dB.
THD+Noise: Less than 0.006%.
Signal-To-Noise Ratio:Greater than -90 dB
Filter Type: 18 dB/octave Butterworth state-variable filters.
Crossover Frequencies -
Stereo: LOW/HIGH: 100 Hz to 10 kHz in two ranges. -
Mono: LOW/MID 100 Hz to 10 kHz in two ranges. MID/HIGH 100 Hz to
10 kHz in two ranges.
Input Impedance: 20 k Ω unbalanced, 40 K Ω balanced.
Maximum Input Level: +21 dBu (ref.:0.775 Vrms).
Output Impedance: 51Ω unbalanced/102 Ω balanced.
Maximum Output Level: +21 dBu (ref.:0.775 Vrms).
Dimensions: 19”(L) x 5”(W) x 1.75”(H).
Weight: 4.38 lbs.