9
Connecting Multiple Speakers
If you must connect more than one speaker per channel, there are two methods in which to do so:
Series or Parallel. Parallel connections are harder on the amplier than series connections, as
the total impedance is lower compared to driving a single speaker, and the amplier must produce
more current to drive them. The following diagrams show “bridged” connections from the amplier.
For more in depth information on series and parallel speaker connections, please visit the DAT website
at www.diamondaudio.com
D6 700.4 4-Channel Amplifier
4 Channel Mode, 1 speaker per channel
Channel Mode, 1 pair stereo plus one bridged channel
2 Channel Mode, both pairs of channels bridged
D6 450.2 / D6 1000.2 2-Channel Amplifier
2 Channel Mode, 1 speaker per channel Bridged Mode
D6 1200.1 Mono Amplifier
If you are connecting more than one speaker per channel, please see the next section.
Mono Mode (This is the only conguration for this amplier)
Left Speaker Right Speaker
LF Speaker RF Speaker
LR Speaker
RR Speaker
LF Speaker
RF Speaker
Subwoofer