DeWalt 06A01 Headphones User Manual


 
OWNER’S MANUAL — Please read before using this equipment.
©
2001 RadioShack Corporation. All Rights Reserved.
Compaq is registered by the U.S. Patent and Trademark Office.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
Multimedia Headset
with Noise Cancelling Microphone
Your Compaq Multimedia Headset delivers
full frequency coverage for use with your
multimedia computer. The headset is light-
weight and has a self-adjusting headband for
a good fit. The flexible gooseneck micro-
phone boom’s 270
°
rotation angle lets you
rotate and bend the microphone boom to a
comfortable position.
OPERATION
Caution:
Turn down the volume on your
sound source before connecting the head-
set.
1. Insert the headset’s orange plug into the
1
/
8
-inch (3.5-mm) stereo phone (speaker
out) jack on your PC’s sound card, and
the headset’s pink plug into the micro-
phone jack on the sound card.
2. Put on the headset, then adjust the
headband and microphone boom for a
comfortable fit.
3. Adjust the sound source’s volume to a
comfortable level.
Listening Safely
To protect your hearing, follow these guide-
lines when you use the headset.
Set the volume to the lowest setting
before you begin listening. After you
begin listening, adjust the volume to a
comfortable level.
Do not listen at extremely high volume
levels. Extended high-volume listening
can lead to permanent hearing loss.
Once you set the volume, do not
increase it. Over time, your ears adapt
to the volume level, so a volume level
that does not cause discomfort might
still damage your hearing.
CARE
Keep the headset dry; if it gets wet, wipe it
dry immediately. Use and store the headset
only in normal temperature environments.
Handle the headset carefully; do not drop it.
Keep the headset away from dust and dirt,
and wipe it with a damp cloth occasionally to
keep it looking new.
Modifying or tampering with the headset’s in-
ternal components can cause a malfunction
and might invalidate its warranty. If your
headset is not performing as it should, take it
to your local RadioShack store for assis-
tance.
SPECIFICATIONS
Frequency Response
Headphone ........................................ 30–15 kHz
Microphone ...................................... 100–10 kHz
Sensitivity
Headphone .................................... 102 dB ±5 dB
Microphone .................................... –44 dB ±5 dB
Impedance ............................................. 32 ohms
Maximum Power Input ........................... 400 mW
Gold-Plated Plugs ....................
1
/
8
inch (3.5 mm)
Length of Cord ................................ 9 ft. (2.75 m)
Specifications are typical; individual units
might vary. Specifications are subject to
change and improvement without notice.
33-1168.fm Page 1 Wednesday, August 8, 2001 8:29 AM