Filter
Top Products
ENGLISH
Operation
• Make sure that all the connections are proper by
referring to the rear panel.
• Check the polarity (positive and negative) of
connections, and the directivity of stereo separation
(right cord to right channel terminal, and left cord to left
channel terminal).
• Check the directivity of pin cord connection.
Preparation
2 Setting of each knob
•Turn the VOLUME control knob counterclockwise, to
minimum position.
• Set the BASS, TREBLE and BALANCE control knob, to center
position.
• Set SOURCE DIRECT switch to “OFF (
£)”.
After checking the above items, turn on the power, the amplifier
is set in the ready mode in a few seconds.
2 Checking connections
VOLUME
SOURCE DIRECT INPUT SELECTOR
REC OUT SELECTOR
P.DIRECT
TREBLE
BALANCE
BASS
FUNCTION
MUTING
CALL
CLEAR
PROGRAMDIRECT
123
456
789
+100
VOLUME
POWER
FUNCTION
1
Select the input source to be played.
FUNCTION
(Main unit) (Remote control unit)
When “PHONO” is selected, press the CARTRIDGE
switch on the rear panel of the main unit to select “MC
(
¢)” or “MM (£)”.
2
Start playback on the selected component.
3
Turn the VOLUME, BASS, TREBLE and
BALANCE control knob to yield an appropriate
volume and sound quality.
For operating instructions, refer to the component’s
manual.
NOTE:
If P. DIRECT button is set to ON position, P. DIRECT terminals is
selected, and input indicator.
Playing the input source
9
ENGLISH