Denon AVR-3802 Stereo System User Manual


 
23
6
BAND MODE
TUNING
TUNING
Set the distance between the
center speaker and listening
position.
The distance changes in units of 1
foot (0.1 meters) each time the
button is pressed. Select the value
closest to the measured distance.
If Yes is selected for Default, the settings are automatically reset
to the default values.
Please note that the difference of distance for every speaker should be 15
ft (4.5 m) or less. If you set an invalid distance, a CAUTION notice, such as
screen right will appear. In this case, please relocate the blinking speaker(s)
so that its distance is no larger than the value shown in highlighted line.
Example: When the distance is set to 12 feet
for the center speaker
7
ENTER
SHIFT
Enter the setting.
The System Setup Menu reappears.
The AVR-3802 automatically sets the optimum surround delay time for the listening room.
NOTE:
If the distance unit is changed after the delay time is set, the settings are reset to the factory default values (see page 16).
Setting the channel level
Use this setting to adjust so that the playback level between the different channels is equal.
From the listening position, listen to the test tones produced from the speakers to adjust the level.
The level can also be adjusted directly from the remote control unit. (For details, see page 49.)
When using both surround speakers A and B, their playback levels can be adjusted separately.
1
2
3
BAND MODE
TUNING
TUNING
ENTER
SHIFT
BAND MODE
TUNING
TUNING
At the System Setup Menu select Channel Level.
Switch to the Channel Level screen.
Select Test Tone Mode.