Filter
Top Products
7
ENGLISH
ENGLISH
Operation
Opening and closing the drawer and loading a
disc
3
2
[NUMBER]
(0~9, +10)
[DISC SELECT]
[
9
]
1
[8]
5
DISC SKIP
<POWER>
5
DISC SKIP
12
<
7
/
9
>
<
8
/
6
>
3
About the button names in this explanation
<>: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
Operation
Press 5.
•Make sure the drawer is completely open.
Hold the disc by the edges and place it on the disc tray. (Do not
touch the signal surface, i.e., the glossy side.)
1
Set the disc properly in the tray according to its size.
•Set 8 cm discs in the center hole.
•Set 12 cm discs in the outer hole.
2
Press DISC SKIP.
The carousel turns and a disc can be loaded in the another disc
tray.
When the drawer is opened during the play mode, it is possible
to load and unload discs in all of the disc trays other than the one
whose disc is currently playing.
3
Press 5 again.
4
NOTE:
•The player will not operate properly and the disc may even be
damaged if it is not set correctly.
• If your finger should get caught in the drawer when it closes,
press 5.
• Do not place any foreign objects on the disc tray, and do not
place more than one disc on the tray at a time. Otherwise
malfunction may occur.
• Do not push in the disc tray manually when the power is off as
this may cause malfunction and damage the CD player.
• Do not touch the carousel while it is turning. Also, do not turn the
carousel by hand when it is stopped. Doing so could damage it.
• Do not insert disc where indicated by arrow.
This could damage the internal mechanism in the unit.
LABEL SIDE
UP WARD
Turning the power on
Press
<
POWER
>
.
• When a disc is loaded, playback starts automatically.
• If no disc is loaded “0 000 00:00” is displayed.
¢To turn off the power:
Press
<
POWER
>
again.
NOTE:
•To turn off the power while a disc is playing, be sure to press 2
to stop playback before turning off the power.
1.DCM-390_290_ENG_Last 06.4.13 4:34 PM Page 7