Filter
Top Products
76
6
Pressing ui, select the rst letter of the device
brand name. Then press ENTER.
1
A
B
C
D
E
RemoteSetupGuide
[1/4]
Please select the
first letter of the
brand name
of the device.
DVD
[CH+/-]Page+/-
•The first character is displayed as 1, A to Z.
(Initials for the brand are displayed for each
category.)
For brand names that start with numbers
and symbols, select “1”.
•When there are several pages of brand
names, the pages can be switched by
pressing the remote control unit’s CH + or
CH –.
7
Pressing ui, select the device
brand name. Then press ENTER.
Dantax
Denon
Disney
DSE
Durabrand
Please select the
brand name.
DVD
RemoteSetupGuide
•When there are several pages of brand names, the pages can be
switched by pressing the remote control unit’s CH + or CH –.
NOTE
If the desired brand name is not listed, the supplied remote control
unit cannot control the device. Use the remote control unit supplied
with the device to be used.
Registering preset codes
8
The procedures for registering remote control codes
and remote control preset registration are displayed.
DVD
Denon
30490[1/3]
Device
Brand
Code
1.Press[INPUT SOURCE].
2.Press and hold [DEVICE ON(I)]
for 3 seconds.
3.Input Code with [0-9].
4.Press any key to check device.
OK[QUICK1] NG[QUICK2] Return[QUICK3]
RemoteSetupGuide
NOTE
If a wrong brand name is selected, press QUICK SELECT 3. The
following screen is displayed:
Press [AMP] button. And press
[ENTER] button to return Brand
select menu.
RemoteSetupGuide
O K
Press AMP then ENTER to return to step 7.
9
Press the input source button on which the preset
code is to be registered (BD, SAT/CBL, TV, DVD,
V.AUX, DOCK, GAME1, GAME2 or CD).
•For TV, only the preset code for the categories “TV”, “TV/DVD”, or
“TV/VCR” can be registered.
10
Press and hold ZONE/DEVICE Z for at least 3 seconds.
The zone mode indicator flashes twice.
11
Enter a ve-digit code using 0 – 9.
Press the buttons with an interval less than 10 seconds.
DVD
Denon
30490[1/3]
Device
Brand
Code
1.Press[INPUT SOURCE].
2.Press and hold [DEVICE ON(I)]
for 3 seconds.
3.Input Code with [0-9].
4.Press any key to check device.
OK[QUICK1] NG[QUICK2] Return[QUICK3]
RemoteSetupGuide
•When the code is registered.
The zone mode indicator flashes twice.
•When the code is not registered correctly
The mode indicator slowly flashes once. Perform from step 9
again.
•When an input number is not correct
Press ON once then perform the operations from step 9 again.
12
Operate the device being used to check the operation.
•If the device is operating, press QUICK SELECT 1.
Go to step 13.
•If the device is not operating, press QUICK SELECT 2.
Go to step 14.
13
The screen shown below is displayed, and registration
of the preset code is completed.
Remote Setup Guide is finished.
Press [AMP] button. And press
[ENTER] button to return MENU.
RemoteSetupGuide
O K
•The menu screen is retrieved. Press AMP then ENTER.
Basic version
Advanced version
Information
Advanced version
vSee overleaf