Filter
Top Products
Step by Step Installation
The included template is the exact size of the required speaker
opening. Once you have decided on a general location for your
speaker, hold the template in the preferred position on the wall
or ceiling and trace around it taking care that the opening is level.
Use a saw or knife to cut the opening.
Run color coded wires between the speaker cavity and the
amplifier unit. When running the wires inside the wall to the opening,
leave a minimum of 12" of additional length in the cavity to facilitate
speaker connection.
Connect the speaker wires to the In-Wall unit taking care to make
red to red (“+”) and black to black (“-”) terminal connections.
Refer to your amplifier or receiver loudspeaker wiring instructions,
turn off the unit and connect the speaker wires to the appropriate col-
ored output terminal on the unit, again making red to red (“+”)
and black to black (“-”) connections. This will ensure absolute phase
throughout the system.
The metal pivoting dogs are pre-installed in the loudspeaker frame
with Phillips screws. The dogs can be rotated left or right by turning
the screws.
To install speaker, fi
rst rotate screws one-half turn counter clock-
wise
to swing the dogs into position to clear the edge of the wall
cutout. Then place speaker frame in position in the cutout and rotate
screws clockwise one-half turn to grip the wall and tighten by hand
until frame is stable but loose enough to be adjusted in final position.
Level the speaker frame and snug screws into place taking care not
to overtighten.
Fit grill on frame.
On the UIW 55, 65 and 75, you will note that there is a two position
switch marked HF EQ on the top of the crossover circuit board facing
the speaker baffle. This can be set to either H (brighter) or L (less
bright), depending on personal listening preferences as well as your
chosen mounting position.
High Frequency Equalization Switch
5