Definitive Technology Solo Cinema Integrated Home Theater System Speaker User Manual


 
17
On-Screen Display (OSD) Set-up Menu Functions
SoloCinema XTR comes out of the box ready to use. Most people will never have to
access any of the following menu functions. But just in case, it is good to be familiar with them.
The on screen menu and brief explanations are shown below. To start, with your TV ON, press
the MENU button on the SoloCinema remote. The OSD screen appears on your TV. To exit the
menu at any time, just press the MENU button. The functions:
1. DOLBY VOLUME: This digital signal processing technology evens out the volume level
of whatever you watch. TV ads that might blast a volume level louder than your favorite
program are instead heard at consistent, equal volume levels. Dolby Volume maintains
the same level when you switch sources, or change cable channels. The factory
preset is ON. To de-activate Dolby Volume, use the arrow keys to highlight DOLBY
VOLUME, and press the right cursor arrow to select CONTROL. Press the right cursor
again to navigate to the On/off selection. Press the cursor’s down arrow to select OFF.
Press ENTER or the left cursor to confirm this selection.
Dolby Volume Modeler optimizes the system performance for low level listening, when
the volume is down, and defaults to OFF in Music mode. The factory preset is ON.
DOLBY VOLUME
CONTROL
MODELER
2. IR REPEATER: The repeater re-transmits the signal from any remote. When table-top
mounting SoloCinema XTR, it is possible that the bar can block the TV’’s IR receivers.
IR Repeater turns on / off the IRflasherslocated on SoloCinema XTR’s rear panel, and
re-sends the IR signal to the TV’s remote eye. The factory preset is OFF. There is also
a 1/8” IR input mini-jack connection for aftermarket IR systems, if required.
SOLOCINEMA XTR MENU
DOLBY VOLUME
IR REPEATER
IR LEARN
SUB CONNECTION
SSA IMMERSION
SOURCE 4 INPUT
HDMI AUDIO
SYSTEM