Filter
Top Products
4. Place another plastic washer on each bolt
so the washer is against the granite.
5. Finger tighten all four bolts into the
threaded holes on the bottom of the
Mythos. If this has been done correctly,
washers will be between the metal
surface of the Mythos STS, the granite,
and the heads of the bolts.
6. GENTLY tighten each bolt with the
Allen wrench. Do NOT overtighten
or you may crack the granite.
7. Attach the AC cord through the hole
at the bottom of the granite base.
8. Note the label showing the height
adjustment ring and locking collar on
the levelling feet. Carefully return the
speaker to the upright position and
adjust the feet to level the speaker.
Installing Cable Clip for AC Cord
The cable clip supplied in the accessories bag holds the power cable in place to
prevent accidental disconnection of the cable from the inlet socket. T
o use, peel
backing and apply to bottom of granite base half-way between center opening and
back of the base, slightly of
f to one side of the rear foot, as shown in the diagram.
After plugging supplied power cable into the inlet socket, it may then be pressed
into the opening in the cable clip to secure it in place.
SUGGESTED CLIP LOCATION
SELF-ADHESIVE POWER CABLE
RESTRAINING CLIP FOR MYTHOS STS
4