Filter
Top Products
© 2007, CyberData Corporation, ALL RIGHTS RESERVED 930194A Quick Reference Quick Reference 930194A © 2007, CyberData Corporation, ALL RIGHTS RESERVED
Connecting Power to the Speaker
Mounting the Speaker
Ethernet
DeviceEthernet
Power injector
Power Injector (Optional)(CyberData #010867A)
PoE
To mount a Wall Mount Adapter:
1. Use the TEMPLATE on the back of this
document to drill four holes in the wall for the
anchors and screws.
2. Place the four PLASTIC RIBBED ANCHORS in
the holes you prepared.
3. Position the WALL MOUNT ADAPTER over
the holes.
4. Use the four #8 SHEET METAL SCREWS to
secure the WALL MOUNT ADAPTER.
5. Plug the Ethernet cable into the IP SPEAKER
ASSEMBLY. The yellow light verifies the
network connection.
Note: You can route the Ethernet cable through
the back or through the slots at the top or bottom
of the WALL MOUNT ADAPTER.
6. Position the IP SPEAKER ASSEMBLY in the
WALL MOUNT ADAPTER so that the IP
SPEAKER ASSEMBLY screw holes align with
the mounting holes in the WALL MOUNT
ADAPTER.
7. Use three 8-32 x 1 1/4” MOUNTING SCREWS
to secure the IP SPEAKER ASSEMBLY to the
WALL MOUNT ADAPTER.
1
2
3
4
5
6
7
Network cable routed through
a wall into the rear of the Wall
Mount Adapter.
7” [178mm]
4 x 0.1875” [4.8mm] Hole for Mounting
10” [254mm]