Crosley Radio CR87-S Turntable User Manual


 
•Marking plate was located on bottom enclosure
11
General
Troubleshooting
Specification
Frequency Range : AM 520 - 1710 KHz
: FM 87.5 - 108.5 MHz
Power Supply : AC 120V ~ 60Hz
Power Consumption : 18W
Speed : 33 /45 /78 RPM
Speaker : 4” 4Ohm 5W x 2
*
DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
There is no Power
1 Make sure the radio is plugged in correctly.
2 Check to see that the power button is
pushed in.
There is no Sound
1 Check the volume level by turning the volume
knob.
Turntable will not work
1 Make sure the function switch is set to phono.
2 Make sure the needle cover is flipped up.
CD does not play
1 Check to make sure CD is inserted correctly
(label side facing up).
2 Check that the surface of the CD is clean
3 Make sure function switch is set to CD.
Turntable is dragging
1 Make sure the Turntable Suspension Screws
are turned clockwise all the way in to allow the
turntable to sit on the suspension.
Needles are available for additional charges,
please call us at 1-866-CROSLEY
www.crosleyradio.com
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lighting flash with arrowhead symbol, within an equilateral
triangle, is intended to alert user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be
of sufficient magnitude to constitute risk of electric shock to
persons.
The exclamation point within an equilateral triangle is intended
to alert user to the presence of important operating and
maintenance (servicing) instruction in the literature accompanying
the appliance.
CAUTION
For Compact Disc Units Only:
INVISBLE LASER RADIATION WHEN OPEN AND INTERLOCK
FAILED OR DEFEATED. AVOID DIRECT EXPORSURE TO LASER
BEAM.
WARNING:
To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
CAUTION:
Use of controls or adjustments or performance of procedures other than those specified
may result in hazardous radiation exposure.