Filter
Top Products
For Fm reception a telescopic antenna (1) is
provided.Extend this antenna fully and rotate to
find best possible reception.
For AM reception a ferrite antenna has been built
in.This antenna is also direction-orientated and it is
recommended to rotate the set for best reception.
SPECIFICATION
FREQUENCY RANGE : FM 87.5 - 108.5 MHz
: AM 525 - 1710 KHz
POWER CONSUMPTION : 5W
POWER SOURCE : DC 1.5 X 4 ‘AA’ UM3 BATTERY
: AC/DC ADAPTOR DC 6V 0.5 A
ANTENNAS : BUILT-IN FERRITE BAR FOR AM
: TELESCOPIC ANTENNA FOR FM
SPEAKER : 3” DYNAMIC TYPE X 1
• DESIGN AND SPECIFICATION SUBJECT TO CHANGE WITHOUT NOTICE.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
The lighting flash with arrowhead symbol, within an equilateral
triangle, is intended to alert user to the presence of
uninsulated "dangerous voltage" within the product's
enclosure that may be of sufficient magnitude to constitute
risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended
to alert user to the presence of important operating and
maintenance (servicing) instruction in the literature
accompanying the appliance.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE. DO NOT REMOVE COVER. PILOT LAMPS SOLDERED
IN PLACE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
Getting Started
Radio Operation
Telescopic Antenna
5
1 This radio will run on battery power or the
supplied AC/DC adapter. To use the AC/DC
adapter, plug the small end into the ADAPTER
JACK located on the back of the radio. Plug
the large end of the adapter into the appropriate
AC wall outlet.
2 To use batteries, remover the BATTERY
COVER SCREW(9). Open the BATTERY
DOOR (6) and insert 4 AA batteries observing
the correct polarity (+,-).
*batteries not included.
1 Turn the unit ON by turning the POWER
SWITCH(3) clockwise to the ON position.
2 Select the desired waveband by placing the
BAND SELECTOR(8) in either the FM or AM
position
3 Turn the TUNING KNOB(5) to select the desired
station.
4 Adjust the volume to your desired listening level.
5 Turn the unit off by turning the VOLUME
KNOB(4) counter clockwise to the off position.