Filter
Top Products
The exclamation point
within an equilateral
triangle is intended to
alert user to the
presence of important
operating and
maintenance (servicing)
instruction in the
literature accompanying
the appliance.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
The lighting flash with
arrowhead symbol, within
an equilateral triangle, is
intended to alert user to
the presence of uninsulated
"dangerous voltage" within
the product's enclosure
that may be of sufficient
magnitude to constitute
risk of electric shock
to persons.
CAUTION: TO REDUCE
THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE
COVER (OR BACK). NO
USER - SERVICEABLE
PARTS INSIDE. REFER
SERVICING TO QUALIFIED
SERVICE PERSONNEL.
CAUTION
For Compact Disc Units Only:
INVISBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED
OR DEFEATED. AVOID DIRECT EXPORSURE TO LASER BEAM.
Specification
Frequency Range : FM 87.5 - 108.5 mHz
Power Source : AC 120V ~ 60Hz
Power Consumption : 30W
Antenna : External Antenna for FM
Speaker : 4” Dynamic Type x 2
Speaker Wattage : 5 W
Speaker Ohm : 4 Ohm
Output Wattage : 2W per channel
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
* DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
9
Troubleshooting
Bubble tubes not bubbling?
1 Make sure stage lights are on.
2 It takes approximately 15 to 20 minutes fro the
bubble tubes to warm up after the lights are on.
3 If the lights have been on at least 20 minutes
and the tubes are still not bubbling, very lightly
tap on the Brown plastic at the bottom of the
radio with your hand. Only tap very gently and
never tap on the tube itself as it could case the
tube to break.
There’s no sound?
1 Make sure the mute function is turned off.
2 Check that the volume is turned up by pressing
vol.+ button on remote.
3 Make sure ext. / int. switch on back of radio is
on int.
(unless you are using external speakers, in which
case it should be on ext.)
4 Check to make sure power is turned on.
5 Make sure the LINE IN switch is in the off position
if not using an external device.
CD does not play?
1 Check to make sure CD is inserted correctly
(label side facing up).
2 Check to see that surface of CD is clean.
3 Make sure radio is on CD function by pressing
CD / Radio button.
Remote not working?
1 Replace batteries.
2 Be sure and point remote towards remote sensor
when using.
3 Remove obstacles in the path of the remote and
the radio so that remote signal has a straight
path to the radio.
General