Filter
Top Products
Antenna System Crestron SRD-ANT-8-PAK
Problem Solving
Troubleshooting
The table after this paragraph provides corrective action for possible trouble
situations. If further assistance is required, please contact a Crestron customer
service representative.
SRD-ANT-8-PAK Installation Troubleshooting
TROUBLE POSSIBLE
CAUSES
CORRECTIVE ACTION
With radio on and all antenna
cables connected at the radio,
check for 4 - 7 VDC at antenna
end of cable.
Short circuits or
discontinuities
With radio on and all antenna
cables connected at the radio,
check for AC voltage at antenna
end of cable; should be < 1 VAC.
If AC voltage is found, check for
ground loops.
Ensure proper cable type and
length(s) per the illustration on
page 2.
Ensure amplifiers are oriented
properly with the output (marked
with an arrow labeled Radio)
oriented towards the radio.
No signal
reception. Radio
display shows:
“Antenna
Disconnected”, or
“Acquiring Signal”
“Check
Antenna” or “No
Signal”
.
Antenna is
connected properly
but signal is too
weak for reception.
Refer to the instructions supplied
with the antenna to ensure the
antenna is pointed accurately.
Limited
reception or
channels
available for XM
and/or SIRIUS
tuners.
Problem with tuner
card.
Ensure that the tuner card is
registered/activated.
Further Inquiries
If you cannot locate specific information or have questions after reviewing this
guide, please take advantage of Crestron's award winning customer service team by
calling Crestron at 1-888-CRESTRON [1-888-273-7876].
You can also log onto the online help section of the Crestron website
(www.crestron.com/onlinehelp) to ask questions about Crestron products. First-time
users will need to establish a user account to fully benefit from all available features.
Future Updates
As Crestron improves functions, adds new features and extends the capabilities of
the SRD-ANT-8-PAK, additional information may be made available as manual
10 • Antenna System: SRD-ANT-8-PAK Installation Guide – DOC. 6724A