Antenna System Crestron SRD-ANT-1LD-PAK
Installation
Installation Notes
• Mount the antenna outdoors with the supplied wall mount or pole mount
accessories. Installation indoors or behind windows is not recommended.
Windowpanes can have tinted coatings that can attenuate the signal. The
attenuation of these coatings can vary greatly as a function of temperature.
• Use the radio’s signal strength display as a guide to adjust the antenna for
peak satellite signal reception.
• This antenna kit is designed to drive up to 350 feet of RG-6 cable with no
signal loss. For longer cable runs, use additional in-line amplifier(s)
SRD-AMP-1 (purchased separately) to boost the signal.
• Although this antenna can receive signals from terrestrial repeaters, it is
recommended to always use the satellite signals for primary reception at
fixed sites. The satellite signals are much more stable and are not affected
by many uncontrolled variables that can impact reception signal quality
greatly over time.
Wall Mounting
Attach the wall mount assembly to a flat surface. Use the supplied screws to secure
the mount in the position desired (use of the included anchors requires 5/16” holes).
Elevation and
Azimuth Adjustments
Vertical Mount
Horizontal Mount
Pole Mounting
Attach the antenna to any pole (not larger than two inches in diameter) using the
U-bolt and bracket with supplied attaching hardware as shown in the figures on the
following page.
4 • Antenna System: SRD-ANT-1LD-PAK Installation Guide – DOC. 6722A