Filter
Top Products
6
FOOT
SWITCH
LEFT
SENDRETURN
SEND RETURN
RIGHT
(CHORUS DRY) (CHORUS WET)
SPEAKER OUTPUTS
100 WATTS @ 4 OHM MINIMUM LOAD
STEREO
EFFECTS LOOP
MONO
EFFECTS LOOP
29 30 31 32 33 34
The Bottom Panel:
27: POWER (not shown): Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom)
of the switch depressed. The switch illuminates when the power is on.
28: AC LINE CORD (not shown): This grounded power cord is to be plugged into a grounded power outlet, wired
to current electrical codes and compatible with the voltage, power, and frequency requirements stated on the bot-
tom panel. Do not attempt to defeat the safety ground connection.
29: SPEAKER OUTPUTS: Use these jacks to connect the amplifier to the speakers. The VTX200 is shipped from
the factory with a cable from each channel connected to the speakers within the cabinet. Additional speakers may
be connected providing the four ohm minimum load rating for these jacks is observed. When using the stereo
Chorus effect the right channel is dry and the left channel is detuned (wet). Each channel will provide 70 watts RMS
into an eight ohm load and 100 watts RMS into a four ohm load.
30: STEREO EFFECTS LOOP RETURN: When using a stereo external effects processor, connect this jack to the
output jack of the effect by means of a shielded three conductor signal cable terminated with a stereo (R/T/S) 1/4”
connector.
31: STEREO EFFECTS LOOP SEND: When using a stereo external effects processor, connect this jack to the
input jack of the effect by means of a shielded three conductor signal cable terminated with a stereo (R/T/S) 1/4”
connector.
32: MONO EFFECTS LOOP RETURN: When using a mono external effects processor, connect this jack to the
output jack of the effect by means of a shielded signal cable.
33: MONO EFFECTS LOOP SEND: When using a mono external effects processor, connect this jack to the input
jack of the effect by means of a shielded signal cable.
34: FOOTSWITCH: Use this jack to connect the footswitch cable (5-conductor midi cable) to the four-button
footswitch (supplied). This allows you to remotely switch between the channels, set tap tempos, save new presets,
and access a second set of DSP presets. (See page 9 for additional information.)
VTX200
Three-Channel Guitar Amplifier with Stereo DSP