Filter
Top Products
INPUT CLEANOVERDRIVE
EQUALIZATION
LEVEL LOW
LEVEL GAIN MID HIGH INSERT HEADPHONES POWER
ON
GX-10
1 4 5 6 7 9 10 1182 3
1: INPUT: Connect your guitar here by means of a shielded instrument cable.
2: OVERDRIVE LEVEL: Use this control to increase the output volume and add “crunch” to
your sound. This control is only active when the Overdrive Gain control (#3) is turned on. For
more information please see the “Getting Your Sound” section on the previous page.
3: OVERDRIVE GAIN: Use this control to along with the Overdrive Level knob (#2) to add dis-
tortion to your sound. The Overdrive Level control is only active when the Gain control is turned
on. For more information please see the “Getting Your Sound” section on the previous page.
4: CLEAN LEVEL: Use this control to adjust the overall output level of the amp. For more
information please see the “Getting Your Sound” section on the previous page.
5: LOW: Use this control to adjust the low frequency output level. Rotating the control counter
clockwise reduces the low frequency output, rotating the control clockwise increases it.
6: MID: Use this control to adjust the midrange frequency output level. Rotating the control
counter clockwise reduces the midrange frequency output, rotating the control clockwise
increases it.
7: HIGH: Use this control to adjust the high frequency output level. Rotating the control count-
er clockwise reduces the high frequency output, rotating the control clockwise increases it.
8: INSERT: Use this jack to connect an external effects device to the amplifier. Use a stereo
1/4” male Y-cord: ring = send, tip = return, sleeve = ground. Send goes to the effect’s input;
return comes from its output. (See the illustration on the previous page for more information.)
9: HEADPHONES: Use this jack to connect a pair of stereo headphones for private listening.
The internal speaker is disconnected when this jack is used.
10: ON LED: This LED illuminates when the amplifier is on.
11: POWER SWITCH:
Use this switch to turn the amplifier on (top of the switch
depressed) and off (bottom of the switch depressed).
12: AC LINE IN: (Rear panel, not shown) The grounded power cord should only be plugged
into a grounded outlet that meets all applicable electrical codes and is compatible with the volt-
age, power, and frequency requirements stated on the rear label. DO NOT attempt to defeat
the safety ground connection.
GX-10
Guitar Amplifier