Filter
Top Products
G40CXL Amplifier
14. DEPTH: This control sets the amount or
depth of the chorus effect.
15. RATE: This control sets the sweep
speed of the chorus effect. Together,
these two chorus controls determine the
overall chorus effect from a slow, “phas-
ing” sound to a lively, shimmering effect
and beyond. The stereo nature of the
G40CXL gives a “three-dimensional”
quality to the unit making it sound full
and “alive.”
16. INSERT JACK: This stereo 1/4” jack is
a line out (tip)/line in (ring) jack.
17. HEADPHONES JACK: Standard
stereo headphones may be plugged
into this jack. This disconnects all
speakers from the unit. allowing private
listening.
18. ON/OFF LED INDICATOR: The amplifi-
er is on when this LED is lit.
19. ON/OFF SWITCH: This is a two-posi-
tion switch; the down position will turn
the unit on, while the up position will
turn the unit off.
RIGHT
MODEL #
120 VAC 60 Hz 200 WATTS MAX LEFT
EXT. SPEAKER
21 22
RIGHT
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
CHASSIS. NO USER SERVICEABLE PAERTS INSIDE. REFER ALL SERVICING
TO QUALIFIED SERVICE PERSONNEL. TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO PAIN OR MOISTURE.
LEFT
LINE OUT
CH. SELECT/
REVERB
CHORUS
FOOTSWITCH
242320
G40CXL
SERIAL #
A
made in USA by
SLM Electronics
1400 Ferguson Ave.
St. Louis, Mo. 63133
20. POWER CORD: Your G40CXL is equipped
with a heavy-duty grounded three-wire
power cord. Be sure this cord is properly
plugged into a safely wired grounded 120
volt, 60 Hz AC power outlet before use. (If
your G40CXL was purchased outside the
United States, refer to the rear panel for
power ratings.) For your safety, never
attempt to defeat the ground connection
on this cord.
21. EXTERNAL SPEAKER JACKS:
These jacks are for additional speaker
hookup. Any number of speakers may
be added since these jacks are in
series with the internal speakers.
22. LINE OUT JACKS: These jacks are
used to connect the unit to additional
amplifiers or to connect the amp to a
tape recorder or mixing board. Using
both the left and right outputs will pre-
serve the proper stereo signal. External
speakers cannot be connected to these
jacks.
23. CHANNEL/REVERB FOOTSWITCH
JACK: This jack is to be used with the
Channel Selector/Reverb footswitch.
24. CHORUS FOOTSWITCH JACK: This
jack is to be used with any standard
footswitch to control the chorus. The
Chorus Switch (13) must be depressed
to enable this footswitch.
REAR PANEL