Filter
Top Products
Basic Operations
English
13 CZ509
∗ The factory default setting is “THROUGH”.
● Adjusting the subwoofer output
volume
You can adjust the volume output from the unit’s
subwoofer output terminal.
2-1. Select “S-W VOL”.
3-1. Press the [ ] or [ ] button to increases
or decreases the subwoofer volume.
∗ The factory default setting is “0”.
(Adjustment range: +6 to –6)
● Adjusting the high pass filter
2-1. Select “HPF”.
3-1. Each time you press the [ ] or [ ]
button to select the setting.
The setting changes in the following order:
“THROUGH” ↔ “60” ↔ “90” ↔ “120”
∗ The factory default setting is “THROUGH”
(through).
Setting the BBE MP
(Sound Enhancement and
Restoration for compressed audio
files)
BBE MP (Minimized Polynomial Non-Linear
Saturation) Process improves digitally
compressed sound, such as MP3, by restoring
and enhancing the harmonics lost through
compression. BBE MP works by regenerating
harmonics from the source material, effectively
recovering warmth, detail and nuance.
∗ This fuction is effective for the audio files in the
CD/MP3/WMA/AAC or USB/iPod mode, but it is
ineffective for the video in the USB/iPod mode.
1. Press the [SOUND] button to switch to the
sound adjustment selection display.
2. Press the [x] or [v] button to select
“BBE MP”.
3. Press the [ ] or [ ] button to select “ON”
or “OFF”.
∗ The factory default setting is “OFF”.
4. When you select “ON”, press the [ ] button,
then press the [ ] or [ ] button to select
as following order.
LOW ↔ MID ↔ HIGH
Notes:
• Manufactured under license from BBE Sound,
Inc.
• Licensed by BBE Sound, Inc. under one or more
of the following US patents: 5510752, 5736897.
BBE and BBE symbol are registered trademarks
of BBE Sound, Inc.
• During SOUND adjustment mode, if no operation
is performed for more than 10 seconds, this
mode can be cancelled and return to previous
mode.
CZ509_ENG.book Page 13 Tuesday, January 13, 2009 10:20 AM