Filter
Top Products
BD216 9
E glis
Setting the Z-enhancer
This unit comes with three types of sound tone
effects stored in memory. Select the one you prefer.
*
The factory default setting is “Z-EHCR OFF”.
Each time you press Z-EHCR button 5, the
tone effect changes in the following order.
“Z-ENHANCER 1” ➜ “Z-ENHANCER 2” ➜
“Z-ENHANCER 3” ➜ “Z-EHCR OFF” ➜
“Z-ENHANCER 1”...
• Z-ENHANCER 1: bass emphasized
• Z-ENHANCER 2: treble emphasized
• Z-ENHANCER 3: bass and treble emphasized
• Z-EHCR OFF: no sound effect
Switching the Clock Display
Press and hold the BND button 0, and then
press the DISP button 9 to swith between the
operation mode and the clock display.
Setting the Clock
1) Press and hold the BND button 0, and then
press the DISP button 9 to display the clock
display.
2) Press and hold the BND button 0, and then
press the DISP button 9 for 2 seconds or
longer.
3) Press the SRCH Up button ¥, then set the
current hour.
4) Press the SRCH Down button ¥, then set
the current minute.
5) Press the BND button 0, then the clock is
set.
Notes:
•
If you select another operation mode while you are
setting the clock, the clock setting operation will be
canceled.
•
If you remove the vehicle’s battery for a check or
repair, the clock will be reset, so you must set it again.
Radio Mode Operations
FM Reception
For enhanced FM performance the
®
tuner includes signal actuated stereo control and
Multipath noise reduction circuits.
Listening to the Radio
1) Press the FNC button 4 to select the radio
mode, then the radio will be on.
2) To select a preset band, press the BND but-
ton 0, then select one of the preset bands
such as FM1, FM2, FM3, FM4, or AM. Every
time the BND button 0 is pressed, the dis-
play will change as:
3) Press the SRCH Up/Down button ¥, then
the station at which there is a broadcast will
be selected (Seek selection).
Manual Tuning
1) Press the BND button 0, then select FM1,
FM2, FM3, FM4 or AM.
2) Press and hold the BND button 0 for 2 sec-
onds or longer, then the display will show
“MANU”, which means that a manual selec-
tion function is on.
3) Press the SRCH Up/Down button ¥ and
select the right station.
Seek Tuning
1) Press the BND button 0, then select FM1,
FM2, FM3, FM4 or AM.
2) If the “MANU” on the display is on, press and
hold the BND button 0 for 2 seconds or
longer. When the “MANU” display is off, the
Seek Selection function is on.
3) Press the SRCH Up/Down button ¥, then
when it selects the station in which there is a
broadcast, it automatically stops.
FM1 FM2 FM3 FM4 AM