Filter
Top Products
4
XLS-28, XLS-12, XLS-15, and XLS-215
CONNECTIONS
1) Fuse Holder
2) Midrange and Tweeter Input 5-Way Binding Posts
(Red=+, Black + -)
3) Jumper Straps
4) Woofer Input 5 Way-Binding Posts (Red=+, Black + -)
normal Wiring: In this method, one pair of speaker wire is
used with one speaker and one amplifier channel. This method is
used in the majority of applications.
Connection: Attach speaker wires to either the Midrange
and Tweeter Input (2) or the Woofer Input (4) 5-way Binding
Posts making sure to leave the Jumpers Straps (3) in place.
Connect the other end of the speaker wires to your Receiver
or Amplifiers speaker output terminals (see your Receiver or
Amplifiers owners manuals for details on this connection).
Make sure to observe correct polarity (Red = +, Black = -) when
making these connections.
bi-Wiring: In this method, two pairs of speaker wire are used
with one speaker and one amplifier channel.
Connection: Remove the Jumper Straps (3) and retain for possible
future use. Attach one set of speaker wires to the Midrange and
Tweeter Input (2) 5-way Binding Posts. Next connect a second set
of speaker wires to the Woofer Input (4) 5-way Binding Posts.
Connect the other ends of the speaker wires to your Receiver
or Amplifiers speaker output terminals (see your Receiver or
Amplifiers owners manual for details on this connection).
Make sure to observe correct polarity (Red = +, Black = -) when
making these connections.
Important: The XLS-6 and XLS-6C cannot be bi-wired.
Wiring note: We recommend that you discuss Normal,
Bi-Wiring, or Bi-Amplifying options with your Authorized
Cerwin-Vega! Dealer and for recommendation on appropiate wire.
XLS-6 and XLS-6C
1) Full range Binding Post
Wiring: One pair of speaker wire is used with one speaker and
one amplifier channel.
impedance:
All CV XLS home speakers are compatible with amplifier ratings
from 4 to 8 ohms. If your amplifier is rated at 4 or 6 ohms, you can
generally play the speaker as loud and as hard as you want and
the energy transfer between the amplifier and your Cerwin-Vega!
speaker will be optimal. If using an 8-ohm amplifier, you can play
loud, but monitor your amplifier’s temperature if you start playing
at extreme volume levels, as the speaker may want to suck more
power from your amp than it can provide.
fuse: Replace only with the correct type and voltage fuse.
Failure to replace with the correct type and value can result in
driver failure that is not covered under your warranty.
Model: Fuse Type:
XLS-28 3A 250V Slow Blow
6.3 mm x 32 mm
XLS-12 4A 250V Slow Blow
6.3 mm x 32 mm
XLS-15 4A 250V Slow Blow
6.3 mm x 32 mm
XLS-215 5A 250V Slow Blow
6.3 mm x 32 mm