Cerwin-Vega P1800SX Speaker User Manual


 
CERWIN-VEGA! PROFESSIONAL
13
P1500X and P1800SX Power Connections - Rear Panel
The P1500X and P1800SX power connections are located on the rear panel. It is suggested to understand the power
connections and descriptions below to insure proper use.
(A) MAIN POWER VOLTAGE SELECTOR
The loudspeaker can be used with 100-120V AC or 220-240V AC power supply lines. Be sure the voltage selector switch
is set to the proper voltage before connecting the power cord. In addition, if the selector is adjusted from its shipped
setting, be sure the proper fuse has been installed. Any failure to meet these instructions may result in damage to the
loudspeaker.
(B) POWER INLET & FUSE
The power inlet is an IEC receptacle type and should only be used with the power cord, or rated-equivalent, that is
included with the loudspeaker.
Below the power inlet is the fuse holder that can only be accessed when the power cord is removed. Be sure to replace
the fuse with rated-equivalent (see Specification section).
(C) MAIN POWER SWITCH
The ON/OFF master switch controls the power to the loudspeaker. Be sure all connections and audio settings are set at a
safe level before placing the loudspeaker into an ‘ON’ condition.
(D) FAN
The fan is automatically controlled by the loudspeaker and provides air-flow ventilation for the internal electronics. The
fan should never be blocked in order to insure proper cooling air flow to the electronics.