Filter
Top Products
Power Switch: 2 position toggle switch off/on controls the AC line voltage
Mute: Terminates (quiets) the output, also operated via remote hand set
Input Select: 4 position rotary switch controls relay input switching
Tape Monitor: 2-position toggle switch engages tape loop circuit
Listening Level: Motorized volume control, manual or via remote, with additional
blue indicator LED in the volume knob.
Dual Output Level Meters: These show output level voltage to the power amplifier, 0
dB is equivalent to 0.775 volts output.
On LED: Indicates internal power supply is power up
Operate LED: Indication of time delay release (approximately 1 minute)
Down LED: Lights up red as remote volume is turned to a lower setting.
Up LED: Lights up blue as the remote volume is turned to a higher setting.
REAR APRON FEATURES
AC Connector: Inlet for the detachable AC power cord, standard IEC plug
AC Fuse: !!VERY IMPORTANT!! ONLY USE 1 AMP Slow Blow FUSE
Remote Trigger: Female 2 circuit jack, 12 VDC @ 400 ma., On when power is on.
Dual Preamp Outputs: Connect to inputs of power amp or powered subwoofer
Tape Out: Constant output of selected input signal for recording, independent of
volume control setting.
Tape In: This is the tape monitor selected input. For use with recording devices that
employ a monitor system to hear the actual recorded signal. May also be used as an
additional line input or an input for an equalizer or other signal adapting device.
CD, Aux1, Aux2 and Tuner: These are inputs requiring line level inputs from source
components. These inputs have wide bandwidth, flat frequency response.