Filter
Top Products
Rear Panel
4
4
1
5
5
2
6
6
2
3
3
1
1
1
1
LOUDSPEAKER BINDING POSTS (OUTPUTS):
* Provide audio output. Two pair of custom-made, high-current Cardas binding posts
labeled + (positive) and - (negative) are included.
* These binging posts are designed to facilitate high pressure, high contact area
connections without the use of tools such as nut drivers. A simple finger-tightening
actually yields higher contact pressure than traditional hex binding posts. There is
no need to exert unusual effort when tightening.
* CAUTION!
NEVER connect power amplifier outputs to any component other than a loudspeaker.
NEVER short-circuit power amplifier outputs.
NEVER connect power amplifier outputs to another power amplifier's outputs.
DO NOT OVERTIGHTEN the A 306 binding posts. Tight, high-contact pressure
connections can be achieved with figer-tightening.
DO NOT FORCE the A 306 binding post "wings" up and over a bent or oversized
connector. Doing so may result in binding post damage. If the connector obstructs
"wing"-turning, slide it into place when the binding post opening provides a snug fit.
Then, use quarter-turns to tighten the connection as needed.
POWER INPUT ( AC IN):
* Connect to an AC power supply using the included power supply cord.
DC TRIGGER INPUT TERMINALS:
* Provide DC trigger control. One 3.5mm mini-jack is available to receive 12V DC
signals from a connected component. Toggling the connected component between
on and standby will toggle the A 306 into and out of standby.
1 1 11
12
RIGHT SPEAKER OUTPUTS
LEFT SPEAKER OUTPUTSRIGHT SPEAKER OUTPUTS LEFT SPEAKER OUTPUTS
MAIN INPUTS
RIGHT CHANNEL LEFT CHANNEL
AC MAINS
TRIGGER INPUT
CARY AUDIO DESIGN, INC.,
A 306 POWER AMPLIFIER
MADE IN APEX, NC, USA.
XLR
XLR RCARCA
1 2
Tip + / Ring -
+3.3 / 24 VAC