Filter
Top Products
6 Incognito passive ceiling speakers
2. Separate about 100mm of speaker cable at each end.
3. Using a wire stripper, remove about 10mm of insulation from
both ends of each conductor, and then twist the strands of each
conductor (fig.1).
4. Observing polarity is of the utmost importance while connecting
your speakers. Ensure that the red (+) terminals on your
amplification system are connected to the red (+) on the
speakers, and black (-) on your amplification system to black (-)
on your speakers (fig.2).
The speaker cable is coded with a bead or stripe down one
lead’s insulation, or has differently coloured wires.
Press the spring-loaded red or black tab back to reveal the
connecting hole. Insert the stripped end of the speaker wire,
then release the tab.
5. If your speakers are wired incorrectly they will be out of phase
and sound hollow and indistinct, with a weak bass. Re-check
your connections for correct polarity and reverse the connections
if necessary.
10mm
100mm
fig.1. fig.2.
Before mounting, ensure that the four fixing screws are slackened off so
that the red mounting dog-legs can move freely.
Move each red dog-leg foot to the LEFT into it’s holding slot, and then
insert the speaker into the mounting hole.
Using a cross-head screwdriver, slowly turn each fixing screw clockwise.
This will move the mounting dog-legs out of their slots.
Tighten each fixing screw until the mounting dog-legs grip the ceiling.
CONNECTING THE SS10
Do not compromise the performance of your system by using
inferior quality speaker cables. We recommend that high quality
cables of 16 gauge or higher be used. Your professional dealer will
give you good advice. Always unplug all A.C. powered components
before making any loudspeaker or component connections. This will
avoid the risk of electric shock or damage to your equipment.
Follow these steps to connect the speaker to your amplification system:
1. Route the speaker cable from your amplification system to the
speakers.
Avoid routing the speaker cable near electrical wires
Do not nail or staple the cable
MOUNTING THE SS10