Filter
Top Products
540A/640A Integrated amplifier
5
Please take a moment to read these notes before installing your
amplifier, they will enable you to get the best performance and prolong
the life of the product.
The unit requires ventilation above and below. Do not situate it on a rug
or other soft surface and do not obstruct the air inlet and outlet grilles
on the underside and top cover. Do not place in an enclosed area such
as a bookcase or in a cabinet.
This unit must not be exposed to dripping or splashing water or other
liquids. No objects filled with liquid, such as vases, shall be placed on
the unit. In the event, switch off immediately, disconnect from the mains
supply and contact your dealer for advice.
Ensure that small objects do not fall through any ventilation grille. If this
happens, switch off immediately, disconnect from the mains supply and
contact your dealer for advice.
Do not route the power cable so that it can be walked upon or damaged
by other items near it.
Electronic audio components have a running in period of around a week
(if used several hours per day). This will allow the new components to
settle down, the sonic properties will improve over this time.
It is recommended that when bi-amping, the same type power amplifiers
are used.
This amplifier has been designed to be left in Standby mode when not
in use, this will increase the life of the amplifier (this is true with all
electronic equipment). If you do not intend to use this unit for a long
period of time, unplug it from the mains socket.
To clean the unit, wipe its case with a moist, lint-free cloth. Do not use
any cleaning fluids containing alcohol, ammonia or abrasives. Do not
spray an aerosol at or near the amplifier.
These units are not user serviceable, never attempt to repair,
disassemble or reconstruct the unit if there seems to be a problem. A
serious electric shock could result if this precautionary measure is
ignored. In the event of a problem or failure, please contact your dealer.
This unit should be installed on a sturdy, level surface. Due to stray
magnetic fields turntables should not be located nearby due to
interference.
INSTALLATION