Filter
Top Products
Site Preparation Guide
15
Verify Component Connector Polarity
The components supplied with your Outdoor Antenna Kit are configured with either
Standard-N connectors or Reverse Polarity-N connectors, subject to the country where
the kit was purchased. Refer to the following table to verify that the polarity of each
connector is correct for your installation.
If you wish to purchase individual components, make sure you specify the correct
N-Type connectors to match the configuration that applies to your country.
ETSI Countries, France, Spain, and
Japan
FCC Countries
A
1 - PC Card connector 1 - PC Card connector
2 - Standard-N Male 2 - Reverse Polarity-N Female
B
Standard-N Female on both ends Reverse Polarity-N Male on both ends
C
Standard-N Male on both ends Reverse Polarity-N Female on both ends
D
Standard-N Female Reverse Polarity-N Male
NOTE
The term Male or Female does not refer to the connector thread,
but to its center pin.
• Male connectors have a solid
center pin.
• Female connectors have a hollow
center pin
Lightning
Protector
(B)
Low-Loss
Cable
(C)
21
Pigtail
Connection
(A)
Antenna
Cable
(D)
Standard-N Male
Standard-N Female
Reverse Polarity-N Female
Reverse Polarity-N Male