Cables Unlimited SPK-24G Headphones User Manual


 
AC Power
1. To operate the speaker using AC power, plug the included 12V power adapter into a
standard wall outlet.
2. Insert the power adapter connector firmly into the DC IN jack located on the back panel of
the speaker.
Operation
1. To switch on the speaker, press the POWER button located on the front panel of the speaker.
The GREEN power LED illuminates.
2. To switch off the speaker, press the POWER button again.
Remote Control
The remote control is ready to use with a factory-installed button cell battery. It can be stored
in the recessed area on the front panel.
Basic Operation
1. When the transmitter power adapter is connected and plugged into a standard wall outlet, the
transmitter's GREEN led remains on.
2. To switch on the speaker, press the POWER button on the front panel of the speaker. The
GREEN led illuminates.
3. Turn on the audio source the transmitter is turned off for less then 4 minutes, the blue LEDs
on the transmitter and the speaker illuminate when the audio signal link between the two is
made.
4. If the audio source connected to the transmitter is turned off for less than 4 minutes, the
BLUE leds on the transmitter and the speaker remain on, but no sound is transmitted.
When the audio signal returns to the transmitter, sound is transmitted again.
5. If no signal is detected for more than 4 minutes, the transmitter automatically turns off ; the
BLUE leds on the transmitter and the speaker switch to GREEN.
6. If no signal is detected from the transmitter for more than 5 minutes, the speaker
automatically shifts to Standby mode.
7. To turn on the speaker again during Standby mode, press the POWER button on remote
control unit.
8. If no audio signal is detected from the transmitter for more than 15 minutes, the speaker
automatically turns off. The GREEN led goes off.
9. To switch on the speaker, press the POWER button on the front panel of the speaker.
10. To switch off the speaker. Press the POWER button again.
Mood Light
For mood light effect, press the LIGHTS button on the speaker or remote control.