Filter
Top Products
COMPOSITE DISTRIBUTION AMPLIFIERS
Video
Gain: 2 Volt unterminated, 1 Volt Terminated: 75 ohms +
5%
Input Impedance: 75 ohms +
5%
Output Impedance: 75 ohms + 5%
Video Insertion Loss: 50 Hz to 10 MHz < .40 dB
In to Out Isolation: 50 Hz to 10 MHz 32 dB Port to Port
Out to In Isolation: 50 Hz to 10 MHz 60 dB
Return Loss: 50 Hz to 10 MHz 20 dB
Video Bandwidth: > 10 MHz (AV400, AV700, AV400SV)
Audio
Gain: Unity
Input Impedance: 22k ohm
Output Impedance: 1k ohm
THD: 0.05% at 1.0 Volts input level
Frequency Response: 20 Hz to 100 KHz
Channel Separation: > 75 dB @ 1 KHz
In to Out Isolation: 60 dB
Out to Out Isolation: 60 dB
Signal to Noise: 100 dB re 2 Volts (out)
A/V Input/Outputs: Model AV400 & AV700, RCA type Phono Jacks
Model AV400SV - 4 pin Din for video
Power Requirement: 15 Volts DC @ 400 mA, 15 Volt DC @ 600
mA with 2.5 mm Power Jack. Power Supply Included
high performance, prograde
A/V Distribution Amplifiers
AV400SV, AV400, AV700
Daisychain to large number of televisions with equal picture quality. Save the expense of additional
A/V receivers and allows up to 150 ft. runs.
DVD or Digital Set-Top Receiver
HIGH PERFORMANCE
AUDIO AND VIDEO
COMPONENT
DISTRIBUTION AMPLIFIER
True One to One Ratio
Four Output
Model AV400SV
CABLE ELECTRONICS, INC.
HIGH PERFORMANCE
AUDIO AND VIDEO
COMPONENT
DISTRIBUTION AMPLIFIER
True One to One Ratio
Four Output
Model AV400SV
CABLE ELECTRONICS, INC.
HIGH PERFORMANCE
AUDIO AND VIDEO
COMPONENT
DISTRIBUTION AMPLIFIER
True One to One Ratio
Four Output
Model AV400SV
CABLE ELECTRONICS, INC.
Call 1.800.767.6189 or 469.429.9200
3209 Wood Drive • Garland, Texas 75041
www.celabs.net