Filter
Top Products
MPS2 POWER SUPPLY
REMOTE TRIGGER OUTput PINS
A 12Vdc signal will be present
on the OUT pins of the Remote
Trigger Connector whenever
the MPS2 is activated. This
control signal can be used
to operate other equipment
with suitable remote control
inputs, such as Bryston SST
series power amps.
SWITCHED TRIGGER OUTPUTS
Whenever a BP26, which is
connected to one of the 4
MPS2 outputs, is turned on
and NOT muted, a control sig-
nal of 12Vdc will be present
on the respecitve SWITCHED
TRIGGER OUTPUT pins of
the of the MPS2 power sup-
ply. This control signal can
be used to turn on suitably
equipped ampliers and other
equipment.
POWER SUPPLY CORD
Use only power sup-
ply cords supplied by
Bryston Ltd. to connect
the MPS2 power supply
to other Bryston equip-
ment. The MPS2 is not
intended to operate any
equipment other than
specically designated
Bryston preamps, cross-
overs and other audio
processors.