Filter
Top Products
Fold Fold Fold Fold Fold
pair, select “Bop”. If prompted,
use 0000 as a PIN for the
pairing code. Once the
speaker is selected, the LED
Indicator will flash slowly and
beeps will sound to confirm
pairing complete.
1. Play your audio device as you
normally would,
2. Volume may be adjusted on your
audio device or by pressing and
holding the '+' or '-' buttons.
3. A single press of the '+' or '-'
button will advance to the next
track or go back to the previous
track.
4. To pause audio, press the '>'
button on the Bop Speaker. To
resume audio playback press
the '>' button again.
5. Slide the Power Switch to OFF.
The LED will go out.
LISTENING TO YOUR
AUDIO DEVICE
SPECIFICATIONS
Power Supply: 5V, 500mA
Total Output: 3W
Range: Class 2, up to 33 ft (10 m)
Li-ion Rechargeable Battery: 400mAh
Speaker: 1.50 inch, 4 Ohm
Charging Time: Approx. 2.5 hours
Battery Life: Approx. 9.5 hours
Compatibility: Bluetooth
®
2.0 or above
device with A2DP/AVRCP/HFP/HSP
The Bluetooth
®
word mark and logos
are registered trademarks owned of
Bluetooth SIG, Inc. and any use
of such marks by Brookstone is under
license.
CARE AND STORAGE
1. Store the speaker in its compact
form in a cool, dry place.
BASIC CELLPHONE OPERATION
1.
2.
3.
4.
5.
When you have an incoming call,
the speaker sounds an incoming
call tone. Both the speaker and
your cellphone may ring, depending
on your cellphone settings.
To answer an incoming call,
short press Play/Pause Button to
answer the call.
To reject an incoming call,
long press Play/Pause Button to
reject the call.
To end a call, short press
Play/Pause Button once.
If, while you are listening to music,
your phone rings and you answer
the call, the music selection will then
continue from where it had stopped.
CHARGING THE SPEAKER
1. Connect the USB Cable
(included) to the Micro USB
Port on the speaker.
2. With the speaker’s Power Switch
off, plug the other end of the
USB Cable into a USB Port on
your computer.
3. The LED Indicator will illuminate
red while charging, and the light
will go out when the speaker
is fully charged. Charges in
approximately 2.5 hours for up to
9.5 hours of listening enjoyment.
PAIRING YOUR DEVICE
1. Prepare your device to pair using
Bluetooth
®
, making sure you are
within 33 feet of the speaker.
Refer to your device’s owners
manual for details if necessary.
2. Slide the Power Switch to ON.
The LED Indicator light will flash
quickly and the speaker will sound
beeps to enter auto-pairing mode.
3.
The speaker will wait for a
connection in pairing mode for
4 minutes. If it does not pair with a
device, it goes into sleep mode. To
enter pairing mode again, power
the speaker off and then on.
4. Once the speaker is in pairing
mode and your device is ready to