4
VR1/VRB VR2 or VR3
Speaker terminal
jumper straps in place
VRC
surround sound receiver or amplifier
left front
center front right front
Basic Hookup
1. Connect the speaker terminals to the amplifier speaker outputs.
2. Make sure the speaker terminal jumper straps are in place on the back of the speaker. (VR2 and VR3 only)
IMPORTANT: When making all connections, be sure to connect + to + (red) and – to – (black).
Bi-wiring (VR2, VR3 only)
Bi-wiring increases the flow of current and decreases intermodulation of different frequencies by providing separate inputs
to the woofer and midrange/tweeter sections. Bi-wiring will usually improve the sound quality, although the improvement
may be quite subtle. If you choose to bi-wire, use the same type and length of wire for all connections. When making all
connections, be sure to connect
+ to + (red) and – to – (black).
1. Unscrew both sets of terminals and remove the jumper straps.
2. Connect the wir
es from the amplifier’s speaker terminals
to each individual set of terminals on the back of the speaker as shown.
Connecting the Speakers to Your Amplifier or Receiver
Remove jumper straps
VR2 or VR3
amplifier or receiver
Remove jumper
straps