15
Troubleshooting
The power won’t come on/
the CHECK indicator doesn’t light
●
Is the specified adaptor (PSA-series,
sold separately) properly connected?
Check the AC adaptor connection (p. 7, p. 8).
* Never use any AC adapter other than one specified
for use with the FDR-1.
●
Is the battery low or dead?
Replace it with a new battery (p. 14).
* The battery that is supplied with the unit is for
temporary use, intended primarily for testing the
pedal’s operation.
* The use of an AC adaptor is recommended as the
unit’s power consumption is relatively high. Should
you prefer to use a battery, please use the alkaline
type.
* To prevent unnecessary battery consumption, be
sure to disconnect the plug from the INPUT jack
when not using the effects unit (p. 5).
●
Is your guitar properly connected to the
INPUT jack?
Check the connection once more (p. 7, p. 8).
* The power is switched on only when a cable is
plugged in to the INPUT jack.
* The CHECK indicator shows whether the effect is
being applied or not. It does not indicate whether
the power to the device is on or not.
No sound / low volume
●
Is your instrument properly connected
to the FDR-1?
Check the connection once more (p. 7, p. 8).
●
Is the LEVEL knob set too low?
The further counterclockwise you turn the
LEVEL knob, the more the volume is re-
duced when the effect is on. Turn the LEVEL
knob clockwise to increase the volume.
●
Is the volume turned down on any guitar
amp or effects device you have connect-
ed?
Check the settings of the connected device.
●
Is the battery low or dead?
Replace it with a new battery (p. 14).
Effect won’t turn off
●
Could you be in the vibrato rate setting
mode (p. 12, p. 13)?
FDR-1_e1.book 15 ページ 2007年1月5日 金曜日 午後6時7分