Filter
Top Products
14
Setting Up Your Lifestyle
®
Stereo Amplifier
Setting up the RC28S remote
Your second remote is shipped from the factory already set up for Zone 2. To make sure that
this remote will work with your home entertainment system, do the following to check the
house code setting.
1. Remove the remote control battery cover and locate the microswitches (Figure 8).
2. Make sure that the house code settings (switches 1, 2, 3, and 4) match the house code
settings in your main room remote.
3. Make sure switches 5, 7, and 8 are up, and switches 6 and 9 are down.
Note: Refer to your Lifestyle
®
system owner’s guide for more information on operating your
system in more than one room.
Figure 8
Remote microswitches
Setting the Zone 2 Protocol in your home entertainment system
For the Lifestyle
®
stereo amplifier to work properly with a Lifestyle
®
media center, you will
need to set the Zone 2 Protocol to Legacy mode (Figure 9).
1. Turn on your Lifestyle
®
DVD system and your TV.
2. Press the Settings button on your main room remote control.
3. Scroll down the menu to System Setup and press the Enter button.
4. Scroll down the menu to the last item, Zone 2 Protocol.
5. Press the right arrow remote button to change the protocol from Normal to Legacy.
6. Turn the system off and on again to ensure that the Zone 2 Protocol is reset to Legacy.
Figure 9
Setting Zone 2 Protocol
ON
House code switches must
match main room remote
Settings ( )
System Setup
System Setup (3 of 3)
Zone 2 Protocol: Legacy
S
O
U
R
C
E
/ IN
P
U
T
MENU / NAVIG
A
T
IO
N
S
e
e
k
C
h
a
n
n
e
l
C
h
a
p
te
r
P
re
s
e
t
T
ra
c
k
Volume
S
to
p
P
a
u
s
e
P
la
y
P
L
A
Y
B
A
C
K
T
u
n
e
D
is
c
O
n
O
ff
Mute
A
ll
Mute
C
D
/D
V
D
C
h
a
n
g
e
r
FM/AM
S
e
ttin
g
s
E
n
te
r
1
2
3
4
5
6
7
8
9
0
S
h
u
ffle
R
e
p
e
a
t
T
V
V
C
R
A
U
X
Settings
Enter