Filter
Top Products
17
G
ETTING YOUR HEADSET READY FOR USE
Notes
For use with a stereo intercom, connect the left and right channels to
their respective positions. For monaural operation, connect pins 3 &
4 together to the tip of the existing phone jack.
Do not use excessive force or bend the installed connector. This may
damage or break internal solder joints.
If the boom microphone works on radio transmit but not through the
intercom, check pin 6. It may be incorrectly wired to the PTT seg
-
ment of the microphone jack.
The wires connecting pins 3 & 4 and pins 5 & 6 are shielded, twisted
pairs with a black wire shield termination exiting each pair. If existing
wiring is not shielded, connect shields to existing audio wiring
shields, or connect shield from Comm L and Comm R wire pair to
audio ground.
The Bose
®
aircraft panel connector cannot be installed to an audio
system using transformer-coupled audio outputs. Call the Bose Avia
-
tion Headset Department for details.
Use proper adhesives
Adhesives approved for use with this connector are:
• Ciba-Geigy Uralane 5754-A/B
•Lord 710
•VTCS-6 Vibratite
Do not let cyanoacrylate-based adhesives, flux remover, or other
caustic compounds contact the connector body. These chemicals
cause irreparable damage to the connector. For information on
chemical compatibility and connector part number, call LEMO
®
USA,
Santa Rosa, CA at 1-800-444-5366.